SAGEM S2000-1 IMMO OFF TESTED SOLUTION NEEDED

[ELAB014]

Hi mates,
I need to put a donnor unit into a car and it seems that this ECU are quite hard to work with.

I?ll give you some more info
CITROEN XSARA PICASSO/ 2001/ 1800 85KW/ 6FZ/
SAGEM S2000-1/ PSA 21646654/ 9645027280
EEPROM 95080/ FLASH 29F200BB TSOP48/ SW NUMBER 9645027280

THX TO ALL :cheers::cheers::cheers:

[credoline]

You need to open ecu, cut silicone on proper place, unsolder eeprom 95080, read eeprom from old ecu, write in new ecu and ...

[Zmann]

File attached doesn't that mean digging up the silicone has been done ?

[ELAB014]

Hi mates,
I read the eeprom and the flash in the donnor unit via k-line making boot loading with trasdata
In original ecu I couldn?t make it this way because It was broken. So, I unsoldered the eeprom and wrote into new ecu.
(this 95080 has data protection). In this case changing de data protecction FF for 00 I could write, anyway the best is to write in new one.

After that I tried into the car and It doesn?t start and there is no COM betwen the car and diagnose machine.

The operation I would like to make now, is to make just IMMO OFF in the donnor unit and put back into the car.
IS IT POSSIBLE???

THX TO BOTH FOR YOUR HELP

[Zmann]

should be possible, I found some good off files for S2000 and this one too work for me http://www.digital-kaos.co.uk/forums/f178/need-immo-off-sagem-s2000-22-a-261617/ post#7 but you may need to do configuration as per your car.

trasdata, the tool name? please more details

[ELAB014]

I can make IMMO PARTIAL OFF with ecuvonix soft.
If I write original eeprom in donnor one, should It work?

Trasdata is the tool from dimsport. I read mostly of the ecu?s in bench via BDM, K-LINE, BOOTLOADER... Really good tool, anyway it?s original, probably, clone one works but the pluggins come from their server.

[Zmann]

If I write original eeprom in donnor one, should It work?

Yes, it should

[ELAB014]

Thanks to both for your help,
Well, I?ll try again with another donnor to write back the original eeprom file
In the one I have right now I?ll try to write a file that I have to make immo off

I?ll report once it?s done and see how it goes!!!! :ridinghorse::ridinghorse::ridinghorse:

[ELAB014]

FINALLY JOB DONE, I?LL GIVE YOU MY EXPERIENCE

I tried again with another ECU writing only the original eeprom info. It didn?t work again. So, I suposse that it could be some kind of synchro betwen the eeprom and the flash. (DON?T TRY TO GET THE FLASH OUT, IT WILL BREAK)

I tried with another ECU with the file from another same engine code car with the eeprom file I attach.
This file makes immo off and the car runs fine. There is com with a diagnose machine but the ECU remains with som DTC?S that we are unable to clear.

HOPE MY FILE WILL HELP YOU
PASS IN PM
ENJOY!!! :vroam::vroam::vroam:

[Sarkan]

I just had one of those on the desk.I think,some time ago I tried to do the same but this did not work.Please ask for the password, so to try.

[Romanky]

Please ask for the password, so to try.

Thank

[dalisman]

can i get pass for this file ?

[ninja123]

i have a peugeot 307 with s2000 ecu, lots of bsi problems and cant get it to start, will your file work on this car too?

ninja

[kokorocato]

can i get pass for this file ?

[busaman]

with sagem s2000 car will start with NO immo chip on the board are you sure you have the right EPROM there are 3 locations on that ecu (i know i have done over 20)

[ninja123]

you did peugeot 307 with remove 95080 and all working good?

ninja

[busaman]

with the chip off the board it will run but will have errors and limited to 2500rpm but as a test it should run and yes i have done 307 but you will need to telecode after.

[ninja123]

done with immo file, no telecode :)

[busaman]

it must have been a perfect match to your car normally something doesn't work like air-con cooling fan etc.

[gui2015]

hi thanks send me the password for private

[ELAB014]

Hello mates,

The PW for the file attached is S2000
I tested once and worked

Don?t forget to say thx!!!
:damnmate:

Good luck and BR

[sanchos]

please a dump for xsara piscasso 1,8 16v sagem s 2000-1

[panter21p]

hi send me the password fot file SAGEM S2000 OK, for private

[ayman zwara]

can i get pass for this file ?

[mnem]

hi send me the password fot file SAGEM S2000 OK

[fenir]

Pass Please

[bangreno]

Pass Please

Pass is S2000