Peugeot 307 IAW 6lp1.02 cant write ST010F80 alought i did boot

[roman_auto]

Hi All
Trying to write a vigin file to this after reading it, i did 2 wire bridge like manual but when i do it no communication with the ecu, can some tell how to writ this ecu.

IAW 6LP1.02
MM
Enginw 2.0 RFN

tryind to write it with MPPS V13

Thanks

[roman_auto]

where is all the experts ?

[roman_auto]

up up
in the moment i have Mpps V13 i read the flash very good but when writing have a problem i think something with security, has any one wrote this ecu with Mpps

[ominimicu]

i think u have wrong bridge at MCu . check fgtech documentation. u have the 3 possible case.
Also have u tried flashing without any boot mode?

[roman_auto]

i think u have wrong bridge at MCu . check fgtech documentation. u have the 3 possible case.
Also have u tried flashing without any boot mode?

Yes i tried to flash without boot, it just read and no write, and i dont have Fgtech documante can some some upload a picrure please ?

[ominimicu]

Here
292873292874

[roman_auto]

Here
292873292874

thanks alot man i will try it tomorrow

[roman_auto]

No read, i did as is te picture and no read or write, i did tried with galleto 1260 he is id the ecu but no read or write, and say SK1 ERROR.

[elmassioui]

ok .did you put the right risistor ? &
try to heat the plate

[roman_auto]

ok .did you put the right risistor ? &
try to heat the plate

Yes, i put the right ressistor as the picture, but i didnt heat the plate (why i need to heat up) ?

[atomiczen]

try with galletto v54, i don't think 1260 can handle correctly this ecu

[roman_auto]

i got today the Fgtech v54, but i cant find with the two adaptors where is the K-line i have can high and low but i dont find the K do you know which color is it .

Thanks

[morfej]

Depends what lead u want to use. On OBD connector pin 7 in the k-line almost on all cars.

br