View Full Version : Peugeot 307 IAW 6lp1.02 cant write ST010F80 alought i did boot
roman_auto
22nd December, 2014, 02:26 PM
Hi All
Trying to write a vigin file to this after reading it, i did 2 wire bridge like manual but when i do it no communication with the ecu, can some tell how to writ this ecu.
IAW 6LP1.02
MM
Enginw 2.0 RFN
tryind to write it with MPPS V13
Thanks
roman_auto
22nd December, 2014, 09:35 PM
where is all the experts ?
roman_auto
30th December, 2014, 04:53 PM
up up
in the moment i have Mpps V13 i read the flash very good but when writing have a problem i think something with security, has any one wrote this ecu with Mpps
ominimicu
30th December, 2014, 05:11 PM
i think u have wrong bridge at MCu . check fgtech documentation. u have the 3 possible case.
Also have u tried flashing without any boot mode?
roman_auto
30th December, 2014, 08:23 PM
i think u have wrong bridge at MCu . check fgtech documentation. u have the 3 possible case.
Also have u tried flashing without any boot mode?
Yes i tried to flash without boot, it just read and no write, and i dont have Fgtech documante can some some upload a picrure please ?
ominimicu
30th December, 2014, 08:44 PM
Here
292873292874
roman_auto
30th December, 2014, 11:09 PM
Here
292873292874
thanks alot man i will try it tomorrow
roman_auto
31st December, 2014, 03:20 PM
No read, i did as is te picture and no read or write, i did tried with galleto 1260 he is id the ecu but no read or write, and say SK1 ERROR.
elmassioui
31st December, 2014, 10:53 PM
ok .did you put the right risistor ? &
try to heat the plate
roman_auto
1st January, 2015, 08:26 AM
ok .did you put the right risistor ? &
try to heat the plate
Yes, i put the right ressistor as the picture, but i didnt heat the plate (why i need to heat up) ?
atomiczen
3rd January, 2015, 01:42 PM
try with galletto v54, i don't think 1260 can handle correctly this ecu
roman_auto
4th January, 2015, 09:15 AM
i got today the Fgtech v54, but i cant find with the two adaptors where is the K-line i have can high and low but i dont find the K do you know which color is it .
Thanks
morfej
5th January, 2015, 02:49 PM
Depends what lead u want to use. On OBD connector pin 7 in the k-line almost on all cars.
br
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.