View Full Version : BMW E65 CAS Problem after millage corection
JFR-Tuning
23rd December, 2014, 09:55 AM
Plz M8 i need help
I make a millage correction by a 7er BME E65 2003 for facelift .
After that the car dont want the key. It open not the igniegtion. I know that digiPROG have a correktur funtion for the software of HC12
Please can anyone make this for me
Thanks
read Dump by rosfar.,Read and writre ok
stevan
24th December, 2014, 11:03 PM
check for flash
JFR-Tuning
25th December, 2014, 06:58 PM
Hi mate ,
thanks for the reply but not understand what you mean
have a nice cristmas
simaservis1108
25th December, 2014, 07:54 PM
He means that you should check flash part of MCU,because problem is not in eeprom.
stevan
25th December, 2014, 09:54 PM
Exactly ,reflash with same version like on sticker,,,,,if can found it.
Don;t forget that some times CAS are upgraded SW in service,in that case it is hard to found appropriate ver.
Master01
26th December, 2014, 12:04 PM
đđĐđß$đĐßđßđßđđääđłldkf>>;*;ßßߤߤ;>>;>ßߤ]$ß$÷÷×ßß]¤¤¤]ß$$[ß[¤ĐĐß[ß...
JFR-Tuning
27th December, 2014, 10:30 AM
Thanks M8 i will test and report today
JFR-Tuning
27th December, 2014, 04:44 PM
@Master
grate job, thanks it work. I dont understand only if i look your dump i see the changes but in rosfar i will have a other dump wich i write. i used the eeprom tool of rofar and write and it work
You make me a after christmess gift
Thanks
JFR-Tuning
9th June, 2015, 02:57 PM
Hi m8,
i have no dump for this car to have more power
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.