k0mpresd
31st December, 2014, 12:01 PM
has anyone been able to read/write iflash or enter bsl mode on st10f272 cpu in the haldex gen4 controller?
i have tried st10 flasher tool pulling p0l.4 lo using 1k-2k ohm resistor but st10 flash tool still complains about no bsl response with 12v/ground applied to standard ignition/ground pins on the connecter.
with no 12v/ground applied st10 flasher says 0xe6 instead of 0x5a response received.
i assume the response with no 12v applied is a false response because of cpu/flash controller not being powered up correctly.
datasheet says bsl mode should receive and respond to commands via tx/rx and can via bsl mode.
any info on putting st10f cpu into bsl mode is much appreciated.
pics of board and/or datasheet can be suppied.
i would also be interested in a programmer that can read/write st10f272 cpu. beeprog2 only lists 269 and 275 cpus.
i have tried st10 flasher tool pulling p0l.4 lo using 1k-2k ohm resistor but st10 flash tool still complains about no bsl response with 12v/ground applied to standard ignition/ground pins on the connecter.
with no 12v/ground applied st10 flasher says 0xe6 instead of 0x5a response received.
i assume the response with no 12v applied is a false response because of cpu/flash controller not being powered up correctly.
datasheet says bsl mode should receive and respond to commands via tx/rx and can via bsl mode.
any info on putting st10f cpu into bsl mode is much appreciated.
pics of board and/or datasheet can be suppied.
i would also be interested in a programmer that can read/write st10f272 cpu. beeprog2 only lists 269 and 275 cpus.