Audi A3 Dash Clone

[losing.control]

Hello friends,i got one question about cloning 2 clusters from audi a3 YEAR 2003 diesel with part number 8P0 920 930 F.
Both have same numbers,the only reason i need to clone is because the original from car is drawning battery.My question is if i copy both dumps from eeprom and processor it will run ok?
Thanks for your time

[TULGEYWOODMAN]

Try it and see.

[tunertool]

eeprom + 2x fujitsu/micronas need to be moved

or if you have AVDI you can do it all OBD.

[losing.control]

eeprom + 2x fujitsu/micronas need to be moved

or if you have AVDI you can do it all OBD.

I dont have AVDI.i got only the dash?s here to work on the bench.also the car is very far away.i got UPA 1.3,XPROG-M,R270.Xprog can read this processors?

[tunertool]

Think only fujtsu programmer can read it.

[losing.control]

i have shop audi VW micronas and Fujitsu programmer 2.0,hope this solve my problem.only need to clone the dash,nothing more.
Anyone have experience our work with this tool?

[baze007]

Only 93c86 swap

[losing.control]

Only 93c86 swap

First of all thanks for your reply,are you sure friend,no data encrypted with the processor?got two MB91F366 inside!
im just asking this because i only have the dash?s here,car is very far away from me,so im gathering some good solution.
Thank you

[baze007]

sorry it is impossible........I just talked with my colleague and he told me that it is impossible.....sorry again......its crypto algo

[baze007]

when I change the eeprom you will receive DEF

[losing.control]

So the only way is reading processor and eeprom and write on new dash using Audi VW micronas and Fujitsu programmer?the programmer have that option for this cluster.

[baze007]

So the only way is reading processor and eeprom and write on new dash using Audi VW micronas and Fujitsu programmer?the programmer have that option for this cluster.


Why should you read and re-write change eeprom and 2xMB91F366 it's the same


Both have same numbers

[losing.control]

i was avoiding desolder the 2xMB91... to avoid damage,only for that reason.

[baze007]

i was avoiding desolder the 2xMB91... to avoid damage,only for that reason.

ok ..... that's the easiest way to do the job .... everything else you need a good tool ... that anything else would be a risk

[losing.control]

ok ..... that's the easiest way to do the job .... everything else you need a good tool ... that anything else would be a risk

That why i buy now the programmer for this clusters.hope it runs ok,if not i will do like you sayed.thank you and keep all of you posted about this.this week i receive the programmer.

[losing.control]

hello again,just receive the fujitsu programer but only have the connections for a3 year 2005 with same processor.but mine is from year 2003 and the pinout is not the same.anyone have the correct pinout to read the dash from this year?
thanks