PDA

View Full Version : W164 EZS 3L40K milage correction



BALI7605
4th January, 2015, 01:04 PM
Hello All,

I have a w164 2007 and i need some calculation for the EZS, i've looked at thachosoft but what it come up don't seem to be correct. It is on 198000km and i wanna make it 152000km

Thank you

vasko
4th January, 2015, 01:07 PM
Try to start car....I thing dump is not correct

vasko
4th January, 2015, 01:08 PM
What proggrammer use to read?
?

Rerouter
4th January, 2015, 01:18 PM
I agree, the dump seems very empty, And Vehicle Year / EZS Manufacturer?

BALI7605
4th January, 2015, 01:33 PM
orange5 chip removed on adapter

Rerouter
4th January, 2015, 01:38 PM
For that mask its either:
MC9S12DG128
MC9S12DT128 or
MSE9S12DT128 (Thanks to hcip for the decoder)

So have a shot at reading another type and see if it still comes out the same,

BALI7605
4th January, 2015, 01:39 PM
car is 2007 ezs made by temic i'm trying to unsecure the chip and read it again

BALI7605
4th January, 2015, 01:47 PM
Hello,

I can't read it as MSE9S12DT128 but i have read it as the other 2 types made no difference (copule of byte swaps but the same)

Rerouter
4th January, 2015, 02:20 PM
Ok then, for whatever reason this dump is at 0Km then with no VIN programmed,

Try this

The 24C16 is just because it is the right size for the dump,

Edit: Removed File as it was from a bad read

BALI7605
4th January, 2015, 02:34 PM
Hello,

Unsecured the MCU and here is the reading, is this make sense to any of you ?

Rerouter
4th January, 2015, 02:43 PM
If is 195834 km then we have a winner, and a valid VIN, Here you go.

Only thing i ask in return is some images of where the EZS is hidden,

BALI7605
4th January, 2015, 02:49 PM
Hello,

THANK YOU, i will get you photos tomorrow when i'm fitting it in. but it is pretty standard EZS fitted next to the steering cullom.
I will show it to you tomorrow.

Whereabouts are you in oz?

vageric
4th January, 2015, 02:51 PM
what is exact Original mileage?

Rerouter
4th January, 2015, 02:54 PM
NSW, Sydney,

vageric
4th January, 2015, 02:56 PM
by this ml 164 you have to remove the command to reach the ezs

BALI7605
5th January, 2015, 12:32 PM
Hello,

Here is two photos where the EZS were, the second photo is s bit blury but you can see the screw holds the lower part of the dash to body if you undo that you can easily push out the EZS otherwise there is somekind of bar behind the EZS which kind of restricts it from removal.

Thank you