Rtronics
13th January, 2015, 03:18 AM
Hi, i have no communication to my 2013 w204.
Story.
installed smok can blocker in ezs at 16,000 km. it now has 24,000km.i was under the impression that the can blocker stops the km being transferred to all the other modules in the car. then one can change the km in the dash to 18,000km remove the can blocker connect it all back up and all modules will have the 18,000km. after reading all threads here.
anyway i tried to change the dash from 24k to 18k with fvdi. i clicked get it read the 24k then tried to change it to 18k but it did not change. after i did this i had no communications with any modules. not even airbag module. reading other posts it looks like it is stuck maybe in programming mode or something.
so i removed cluster and changed it manually. put the dash back in the car it shows up the 18k. connected ezs with blocker removed and yes soldered the black small rectangle thing it asked me to remove to install the blocker.
after put everything back i have no communication to anything except with cgw. read that it says no fault codes.
tried with snap-on fvdi original avdi to just read codes and clear no communication. have star tried that again no communication.
car starts but the thermo fan turns on and sounds like its running 1000 miles and hour. command gets message anti theft protectection is activated. it even starts with the cluster out of the car.
what do i have to do to get modules communicating again ?
Story.
installed smok can blocker in ezs at 16,000 km. it now has 24,000km.i was under the impression that the can blocker stops the km being transferred to all the other modules in the car. then one can change the km in the dash to 18,000km remove the can blocker connect it all back up and all modules will have the 18,000km. after reading all threads here.
anyway i tried to change the dash from 24k to 18k with fvdi. i clicked get it read the 24k then tried to change it to 18k but it did not change. after i did this i had no communications with any modules. not even airbag module. reading other posts it looks like it is stuck maybe in programming mode or something.
so i removed cluster and changed it manually. put the dash back in the car it shows up the 18k. connected ezs with blocker removed and yes soldered the black small rectangle thing it asked me to remove to install the blocker.
after put everything back i have no communication to anything except with cgw. read that it says no fault codes.
tried with snap-on fvdi original avdi to just read codes and clear no communication. have star tried that again no communication.
car starts but the thermo fan turns on and sounds like its running 1000 miles and hour. command gets message anti theft protectection is activated. it even starts with the cluster out of the car.
what do i have to do to get modules communicating again ?