clauberty
17th February, 2015, 06:49 PM
Hello
after i program the PCM one TDC is still active: P1635 Tire / Axle Ratio Out of Acceptable Range
Programming was necessary because of eeprom corrupted (eeprom was taken from other cu but not the same part nr)
At this point no esp or check engine is on even with engine started bu on the display engine fault is displayed
Tire size 195/65 R15 is programmed
Axle Ratio 4.33 or 3.41 is available, after configuration esp fail is displayed ESP bulb is on with both values
Is there a way to calculate or is written somewhere the correct axle ratio
I know that i wold need the as-build file but i have no access to ford
if somebody can get the file wold be nice
Ecu 6M51 12A650 NC 9BXC or based on VIN?
Thank you
after i program the PCM one TDC is still active: P1635 Tire / Axle Ratio Out of Acceptable Range
Programming was necessary because of eeprom corrupted (eeprom was taken from other cu but not the same part nr)
At this point no esp or check engine is on even with engine started bu on the display engine fault is displayed
Tire size 195/65 R15 is programmed
Axle Ratio 4.33 or 3.41 is available, after configuration esp fail is displayed ESP bulb is on with both values
Is there a way to calculate or is written somewhere the correct axle ratio
I know that i wold need the as-build file but i have no access to ford
if somebody can get the file wold be nice
Ecu 6M51 12A650 NC 9BXC or based on VIN?
Thank you