aslamaslam
5th March, 2015, 07:39 PM
Fault code 146 on transmission system bmw e46 n42
Fault code 146 " CAN torque interface " there's any one knows what's problem and probable case. Thanks
brunofraga
6th March, 2015, 03:09 AM
P1770 = CAN Torque Interface
The fault is caused when the amount of torque requested is mismatched with what the vehicle can produce. It is usually caused by an engine issue (programming, wiring, bas MAF sensor, etc).
This can be a tough code to trace down without other codes pointing to the malfunction that caused it to set (ie a fault code in the engine control unit).
Due to the nebulous nature of this fault, its multiple possible causes and also the expense that can be involved in an improper diagnosis, I would suggest you have the car scanned using a dealer level scan tool in order to gleam more accurate information as to its possible cause.
aslamaslam
6th March, 2015, 11:18 AM
i test all wires
all is ok
i change mas air
same problem
please i need to raiper this car
best regards
aslamaslam
7th March, 2015, 04:17 PM
any one can help me
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.