Difference in connection between Delphi CRD 2.35 and CRD 2.61

[dudson86]

Hi, i want to connect Galletto to Delphi CRD 2.35, but i have a problem: in instruction to galletto they show to connect yellow wire to the ecu in some place for ecu CRD 2.61 - photo below. My ecu is little bit different than 2.61 - photo2. What do i need to do with this yellow (7) cable ? How connection should look ? I can connect only yellow wire to place shown in 2.61 instruction but i am affraid to brick ecu :/
http://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=304075&stc=1http://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=304076&stc=1
one more pic:

http://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=304081&stc=1

[dudson86]

no one was doing connection to this ecu with galletto ?

[youssef70]

no one was doing connection to this ecu with galletto ?

see page 14 of fgtech manual ?

[dudson86]

i dont see anything interesting on this page, or we dont have same manuals ? http://www.ad-soft.pl/g3/documents/NEW_FGTech_JTAG_MPC55xx_User_Manual.pdf

[dudson86]

i dont see anything interesting on this page, or we dont have same manuals ? http://www.ad-soft.pl/g3/documents/NEW_FGTech_JTAG_MPC55xx_User_Manual.pdf

Ok i've found on this file: http://www.ad-soft.pl/g3/documents/FGTech_JTAG_MPC55xx_User_Manual.pdf

Thanks mate.

[dudson86]

I made right connection with my ecu, when i am trying to connect by jtag module it says: "error osr error setup". What it means ? Do i need to special boot this ecu first? If yes, can someone tell me how to do it ?