MMW E46 320CI Problem sync EWS3 / Bosch ME9.2

[JFR-Tuning]

Hi mate i have a Problem with a E46 320 I Bj 2003

Will not start and the engine do not crank.

In Immo no trouble code in the ECU/ DME i have the trouble code #" EWS / DME connection are lost"

does anyone know what to do

Please can any M8 check the isn codes in EWS and DME ?

EWS >> EWS 3 insite 0D46J read with XprogM
DME >> Bosch ME 9.2 DME 7523838, 0261209005 read with BDM

Thanx in Advance

[smt]

ecu bad read retry again

[JFR-Tuning]

@smt ok.

what is not good, flash mcu or Eeprom

i think Reading id good but dump erase or damaged.?

thanks

any m8 have a full bdm file for this ? Virgin ?

[JFR-Tuning]

Any help ?

need a full bdm file for the ecu , Vergin


318i = 318ti = 318Ci = N42B20
number of cylinders - 4
diameter cylinders - 84 mm
Stroke - 90 mm
Capacity of - 1995 cm ?
Compression ratio - 10,0:1
Maximum output - 105 kW (143 hp)
Revolutions of - 6300 rev

[JFR-Tuning]

Help please for vergin dump

[JFR-Tuning]

please can anyone make isn syn DME and EWS3

[JFR-Tuning]

any help please to check if the isn in DME and EWS3 ok

[rex89]

hi mate isn is ok into two dumps : 36 3B same

[bali motor]

306837

write this data to your ews...
start your car