View Full Version : Mc Cormick tractor chiptune
Fec001
26th March, 2015, 02:07 PM
Hi!
I have a customer who has a tractor with bosch VP44 injection pump and perkins ECU. I want to read this ecu but never met perkins ecus. Someone can check pictures and give advices about reading this.http://tapatalk.imageshack.com/v2/15/03/26/0d489669b5f9b850a19891177fc78f2c.jpghttp://tapatalk.imageshack.com/v2/15/03/26/f5657772d08a32fddbf4882e83f14f33.jpg
FritzP
30th March, 2015, 08:05 AM
Hi!
I have a customer who has a tractor with bosch VP44 injection pump and perkins ECU. I want to read this ecu but never met perkins ecus. Someone can check pictures and give advices about reading this.http://tapatalk.imageshack.com/v2/15/03/26/0d489669b5f9b850a19891177fc78f2c.jpghttp://tapatalk.imageshack.com/v2/15/03/26/f5657772d08a32fddbf4882e83f14f33.jpg
I regularly tune this engines on MF tractors.
You will have to read the ecu with bdm, there is no other option.
However, for write/programming, I use KessV2, there is protocol for writing.
Of course, you can also program with bdm.
I am using BDM100 EVC.
Fec001
30th March, 2015, 08:45 AM
Thanks, can you share BDM pinout and pin1 location?
mislav88
30th March, 2015, 09:56 AM
you have it in fgtech documents
Fec001
31st March, 2015, 09:57 AM
Found!!! But I have eu clone and other type adapter delphi. I think this is the correct connectionhttp://tapatalk.imageshack.com/v2/15/03/31/88c76c42f6022b847a70e26a782dc56f.jpg
mislav88
31st March, 2015, 11:16 AM
check where gnd is on ecu, that way you cant miss
Fec001
31st March, 2015, 12:48 PM
adapter position is correct. Measured pin 3 and 5 to gnd. But thhere is a problem, galetto can't read. Error micro not supported..... :/
EDIT:
CMD read it all ok!!!!!
If someone very familiar with this machine and ECU, feel free to PM.
Dump attached.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.