Xprog 5.5 how to read St10f280 , any adapter ? Rxd,Txd to Xprog

[roman_auto]

Hi all
I have this ecu PSA, i know the ecu pinout, but i need to know how to connect to the Xprog, do i need any adapter for this ? i have connectotr with wiresto the xprog but i can find the connections : Rxd,Txd on the Xprog , if someone can picture it how to connect to xprog.

Thanks

[dominik.m]

NO need any adapter.

[roman_auto]

Yes i have this scheme but in this picture you see there is no Rx or Tx or Pol.4,Reset , so just to connect it like the pins ? regardless to the names ?

[ANDRIKSSON]

Yes i have this scheme but in this picture you see there is no Rx or Tx or Pol.4,Reset , so just to connect it like the pins ? regardless to the names ?

It's very simple. On your photo xprog pinout rotated in 180'.
Connection:
MCU - XPROG

VCC(5V) - VCC
PL04 - B4
RESET - B5
TxD - B2
RxD - B3
GND - GND

[arvedo]

Friend not you spend reading with that tool does not work.
same problem and my solution was piassini + boot mode and it was all ok
:)

[smayer]

Yes i have this scheme but in this picture you see there is no Rx or Tx or Pol.4,Reset , so just to connect it like the pins ? regardless to the names ?

The chinese stick the label upside down

[roman_auto]

Thanks all guys, i did connect it but i dont have function to read just blank and earse, other is in grey, i did read it with Piasini , perfecr :)

[smayer]

Thanks all guys, i did connect it but i dont have function to read just blank and earse, other is in grey, i did read it with Piasini , perfecr :)

:rofl::rofl: try click in "new"...., Don?t blame x-prog, must read instruction manual before use!!

[whim]

i need x prog connection plesea help

rxd ----->b3
txd----->b2
pdx----->?
rst----->?
osc----->?

best regards

[andygtr34]

Hello friends is this micro as it is pinout st10f280 fiat palio
416898
thanks for your help

[nasbadboy]

Hello friends need pinout st10f280
magnetti marelli iaw6lp3.07
peugeot 407

thank you