View Full Version : Citroen c4 picasso
radiosolutions
19th April, 2015, 02:27 PM
57 reg, 1.8 petrol, problem is very strange.when I start vehicle, comes up with message handbrake fault,esp fault, injection fault. Car will only slightly rev up. Scanned with lexia accelerator pedal in live data all fine. Faults stored in engine,p1153 learning of initial settings of motor driven throttle. Abs, u1208 no comms with engine ecu. No faults in parking brake,bsi or any other module. Strange as it comes up with parking brake fault,but no fault codes stored. When this happens all messages come up together. The fault does not happen all the time,sometimes you start and it drives fine. I have replaced battery,and under bonnet fuse board . Can anyone help
easytech
19th April, 2015, 06:14 PM
Replace BSI in the engine compartement.
Probably a faulty relay had such issue with a HDI.
mohad
19th April, 2015, 07:08 PM
clean bsi connector
radiosolutions
19th April, 2015, 07:19 PM
The fuse board in engine has been replaced with new, thanks
Meat-Head
21st April, 2015, 07:44 AM
Did see a Tweet not sure that fault. But remove battery follow loom where French left a bolt to chaff on the loom.
justy22
21st April, 2015, 10:36 PM
Did see a Tweet not sure that fault. But remove battery follow loom where French left a bolt to chaff on the loom.
similar to you leaving hidden remote cut off switches to customers cars so u can repair them at the flick of a button and look good for your litttle fat boss
Meat-Head
21st April, 2015, 11:19 PM
OFF TOPIC:-
Sadly never happened, but ALWAYS planned a 36 hour timer on a certain stwech wimo (guy had a wisp), to hoot the horn, as long as the job was something else of course.
Keep this quiet, but we REALLY DID put a supermarket trolly with no wheels in the trunk.
dreambox50
21st April, 2015, 11:29 PM
did the parking brake working good ? i work in Citroen always c4 PICASSO HAVE PROBLEM IN parking brake SWITCH
radiosolutions
22nd April, 2015, 09:39 PM
Update. Found water in one of engine ecu plugs. Common issue,temp sensor allows water to travel up loom into the plug. Going to replace sensor and clean ecu up,see how it goes .thanks for all help
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.