ROSFAR 270 CLONE

[TOINO]

hello mates! who has rosfar r 270 clone? this works, and if it works in full? someone with experience in rosfar clone? thank you:02.47-tranquillity:

[mercis]

yes good tool,buy from HRT,big box

[aem]

BIG BLACK BOX R270+ work perfect

[djoko.k]

For me works ok but fails on cas 2k79x unknown pin error...

[Mario3]

i have metal blue box version, erasing all kinds od 35080 eeproms works perfect everytime. Failed me only once on a w203 ezs 908 cant remember the mask, but did other 908 perfect. 912 and 9s12 worked everytime... and cas 2k79x worked also

[i_shot_the_sheriff]

Tried the blue edition on a w211 EZS ST12 1L85D and it made the car no start after read............

[TOINO]

can you tell me where purchased, as not all vendors have the same quality!

[fuktak]

Here repair solution found from friend.BR

[sida]

I have R270 black box, also EZS, showing decode 1-3 minutes but it takes forever, never did a job.

[Mario3]

Here repair solution found from friend.BR
interesting is that my board looks different than this one.. I guess i had luck. Never destroyed anything with it

[Niaz]

Did cas4 "1L15Y" 3 hour's ago with metal body r270 .. was bought 800usd ..updated by bolonc ..thanks bolonc ..:) let see what happen tomorrow lol ..

[sida]

Thanks for solution. I guess there is to many different R270s more people I know that have bad then good r270. I will try this solution and report.

[djoko.k]

I have metal blue box and big black box same story for both on cas unknown pin as i said and once did fail reading ezs and while i was trying to read it erased eeprom w203

[GolfmkI]

Perhaps I am a lucky guy, but never had problems with it.

Must say that I always check in forum the mask (this were I am working), if it seems dangerous simply abort.

I think with caution and Knowing what are you doing all tools could be "safe".

But risk is always there, I think even with original...

[captain crackers]

Just wondering. Could any of the problems with the R270 discussed here be undisclosed operator error, or is it always the R270 that is at fault? I have been carefully using one for quite a while now without a problem with any device and mine was the cheapest I could get, in a blue plastic case. Arthur.

[GolfmkI]

Captain crackers

As I Know sometimes there are bugs that makes all eeprom is erased when cannot read ok.

This is the problem ( when cannot read) and sometimes eeprom is erased, and you have not backup.

I think there are some Masks that are very sure to work, and other ones that requires I bit more .

I supose Operator takes all the cautions before, when it fails I think it is device problem. This Job is risky.

Sure there are people with original that have had problems.

I must also say people say RED VERSION is better than BLUE VERSION.

There are hardware differences, or perhaps is better cloned.

Mine is blue one, at this moment have not any problem ( I dont use every day).

[captain crackers]

I am talking about the r270 not the Rosfar R260 (which I have an original). Arthur.

Further to this, To date, I have had only 1 problem using my Rosfar 260 and that was operator error (my fault). Using my R270, to date I have had 100% success. Yet this forum is full of need flash, need eeprom. I don't believe I am lucky, I think it more a case of being very careful, extremly careful . In fact in all the time I have been working with memory devices, the only problems I have had have been because of errors on my part. Arthur.

[Mario3]

I am talking about the r270 not the Rosfar R260 (which I have an original). Arthur.

Further to this, To date, I have had only 1 problem using my Rosfar 260 and that was operator error (my fault). Using my R270, to date I have had 100% success. Yet this forum is full of need flash, need eeprom. I don't believe I am lucky, I think it more a case of being very careful, extremly careful . In fact in all the time I have been working with memory devices, the only problems I have had have been because of errors on my part. Arthur.
i agree 100%, in every case where something bad happened it was always the human factor...

[diagtech]

Not always try using diagprog 3 on w221 s class

[captain crackers]

diagtech, I don't and wouldn't go near any Merc with an NEC EZS or BMWs with cas 4 or FEM units. I have never used a can blocker and never just flashed a dash only, on earlier Mercs. I will only do Renaults with ABS if the customer brings me the dash and ABS removed from the car. The W221 came out in 2005 and now 10 years later the EZS still cannot be done.But if you are prepared to use a cock up method for whatever reason, money, brownie points, customer is a friend etc. then prepare yourself for possible headaches with that kind of job. Personally I dislke headaches and have no need to possibly give myself one. I have no problems telling the customer that I don't do them whatever the circumstances. You see, it is not my fault if the customer has driven too many mies in his W221 and want's a cock up mileage job doing on it. Arthur.