PDA

View Full Version : Seat Exeo 150cv 2009 ME7.5.30 Not start Help



Car28th
27th April, 2015, 10:55 AM
Hi! I have read the ECU by OBD with Galletto V54 and now the car will not start. Only reading. Seems to have decoded the inmo. Can anybody help me? thanks
ME7.5.30
0261S04656
1037399152




Reading ME7.5.30 I used the driver ME7.5.5 know that is not yours but has made me read.



Delphi DS150E say
Immobiliser Status is 6

Thanks

bobolin4o
27th April, 2015, 03:08 PM
What help exactly you expect from here, by just posting this OBD readed flash?

icezero2010
27th April, 2015, 03:52 PM
Hi! I have read the ECU by OBD with Galletto V54 and now the car will not start. Only reading. Seems to have decoded the inmo. Can anybody help me? thanks
ME7.5.30
0261S04656
1037399152




Reading ME7.5.30 I used the driver ME7.5.5 know that is not yours but has made me read.



Delphi DS150E say
Immobiliser Status is 6

Thanks

can u read dtc?s post it please .

Car28th
28th April, 2015, 09:13 AM
Immobiliser module DTC Error 18089 permanent
Engine module DTC 01314 intermittent
Thanks

wiseman
28th April, 2015, 09:58 AM
Write what you just read off and car should start

LaraVAG
28th April, 2015, 10:00 AM
yes, only write

Car28th
28th April, 2015, 11:11 AM
In Boot mode C167 or OBD?

wiseman
28th April, 2015, 11:24 AM
Obd will work

pablo1971
28th April, 2015, 05:36 PM
have you done a diagnostics on the engine....ive had this same fault on one car before...no start after a READ...diag came up with programming not complete...write a original file back over obd and it should start..

Car28th
28th April, 2015, 11:55 PM
I reloaded the .ori for OBD and the car started s the first. It was a strange case. Thank you very much everyone.

icezero2010
29th April, 2015, 09:22 AM
I reloaded the .ori for OBD and the car started s the first. It was a strange case. Thank you very much everyone.

same as opel delco ecu is in programming mode write ori again or disconnect the battery for few minutes