View Full Version : Help !!! Pin out for Mitsubishi Canter EDC16 ??
mexanico1971
28th April, 2015, 02:28 PM
Hi People !
I"m stuck in this one !
car is very far from me and I have FTG 2/3 to read BDM flash , but do not have shore about feed pins of the Plug of the ECU !
does any one have pinout for this ecu ??
thanK"s in Advance
S.W.A.M.I
4th December, 2017, 11:21 PM
Anyone have this ecu pinout?
dtip
5th December, 2017, 12:40 AM
Pinout for what? it is standard edc16 bdm, i did one egr off few weeks ago, i used galletto (reworked) without problem, just use standard bdm pads for edc16 no need to feed power on ecu pins...
edit: geee, i just saw this guy revived 3 years old thread :coat2:
S.W.A.M.I
5th December, 2017, 03:21 PM
Some tools can now do these Via ecu pins on the bench via K-line/CAN , without the need to open ecu.
maajkii
5th December, 2017, 03:22 PM
but whats is sense to do it via pinouts?
its so simple to open and read this ecu..
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.