PDA

View Full Version : EDC16U31-4 BXE MOTOR PROBLEM?



kospoz
30th April, 2015, 08:47 PM
A friend came today with one octavia 1.9 bxe engine with a problem.The car working fine until you put the 5 speed on transmission then the car have black smoke limp mode and code p0299 boost pressure not reached.....He told me that someone did egr off.Can someone check the file?All connections (airtubes) are fine,turbo clean,maf replaced.

kire106ka
30th April, 2015, 11:56 PM
File is ok

nexusjose
1st May, 2015, 05:35 AM
hi, are you check boost pressure control valve n75 , n18,, and sometimes sensor G450 make this fault
Make a log with VCDS or Delphi for see turbo

kospoz
1st May, 2015, 06:21 AM
I saw with vcds that the turbo pressure is ok the car goes into limp mode without hard acceleration.This car has a box with all connections n75,n18 all in one.Maybe this is the problem?With live data when the car is with limp mode the data of boost control shows 6%.

gttuning
1st May, 2015, 08:26 PM
most of time if happens on 5th gear around 100-120 km/h
turbo is the problem

radoslawwiklik
2nd May, 2015, 10:43 AM
IF you have boost control 6% your problem 100% in turbo.

kospoz
2nd May, 2015, 02:15 PM
IF you have boost control 6% your problem 100% in turbo.
6% i have when is into limp mode but why i having this only at 5 gear?The others are ok no smoke

Fantomisback
2nd May, 2015, 02:54 PM
6% i have when is into limp mode but why i having this only at 5 gear?The others are ok no smoke

my friend just remove turbo open and clean exaust side it is stucking

best regards

gttuning
2nd May, 2015, 03:06 PM
my friend just remove turbo open and clean exaust side it is stucking

best regards
it works but short time,get some turbo shop to recon your turbo

kospoz
2nd May, 2015, 04:07 PM
my friend just remove turbo open and clean exaust side it is stucking

best regards
The turbo has been cleaned and i have not any strange sounds from it.I moved the variables with the hand no stucking at all.Also if it was stucking i had trouble with overpressure but now the trouble say boost pressure not reached....

spychu14
4th May, 2015, 08:46 AM
What box ? Some tuning box ? Check wiring from ecu to Boost preasure sensor with light bulb.

radoslawwiklik
4th May, 2015, 09:22 PM
The turbo has been cleaned and i have not any strange sounds from it.I moved the variables with the hand no stucking at all.Also if it was stucking i had trouble with overpressure but now the trouble say boost pressure not reached....

geometry turbine was composed well?You shot the pear?