Volvo s60 2002 Sync Files from Old ECU new ECM

[THeFOg]

Thank you for your help.

I got a lost key situation, i failed to program and with my tries i damage the ECM, i got a new one from same year and tried to sync it to the old ECU here is the information and the files can someone please can check the files for me, car still no go, i checked soldering many times and yet car radio, seats and air condition are the only ones that works for me, i also check fuses in compartment driver side and under the hood and all ok, i even change the relays from the donor car without any success. any advise will help otherwise this one will go to the stealer for lots of $$$$ to fix.

Volvo S60 2002 Vin# YV1RS58D422128393

ECU BOSCH
0261207392 26SA0000 1111
08627757 A
000036045
01327 HS.2 MADE IN GERMANY
EEPROM - 95P08

ECM HW-PN 9452553
8645541
00W382
SERIAL#000000745694
FLASH - 28F400

311991

[lechus111]

311993

try...........

[THeFOg]

Thank you i got the same file as you after i found out i got 2 last bits wrong, still no go, i will start from scratch now, resolder all the eeprom and flash again see where is going to take me, Thank lots m8 hope i get this one sort out, is my flash file look OK?

[Sarkan]

Try this done with ' Volvo Synchro ' utility, first restore CEM data then synchronization with ECU eeprom data.

[lechus111]

starter turns?

[THeFOg]

Thank you Sarkan

Starter turns yes


Thank you for your time

[THeFOg]

I can read the mileage from the car, if I take the chip out of the key car won't crank only, only engine light is on, I checked out all fuses boot hood and driver side I soldered a new 28F400 with donor car got new ecu from a 2nd donor car sync both with the files still car won't start. I am missing something little I know it. Most techs for solder problem or read/write wrong. I was making sure not to damage/write on the donor flash. Any help or advice will help. I either fix or take it Stealer tomorrow. Thank you


Thank you for your time

[alhengary]

i had same problem in my car just check engine light on
i solve that problem by re solder flash
regards

[THeFOg]

Thank you so much for your time

Tried that on 3 different CEM and new flash - no success. I think this one need to go and have fun with the stealer


Thank you for your time