View Full Version : FGTech Galetto v54 problem writing EDC17
Group MB Best
10th May, 2015, 12:02 PM
hello
i want to help me in this problem
when i want to write flash
when it up 4% it give me an error in writing
my ecu it opel insignia EDC17CP19
my picture is
thanks in advance
Music73
10th May, 2015, 12:18 PM
Is your boot pin and extra resistors soldered ok.. I have used mine for this Ecu ok ...
Group MB Best
10th May, 2015, 12:54 PM
i solder boot in ecu ok not working
javyb
10th May, 2015, 02:39 PM
are you writing back the flash from this ecu or from another?
Fantomisback
10th May, 2015, 02:44 PM
i think he write another software number becouse of that he have problem in writing
Group MB Best
10th May, 2015, 04:24 PM
hello javyb
i write it from boot mode tricore
Tachodiag
10th May, 2015, 08:47 PM
you dont understand ... what dump do you intend to write in ecu flash ? the original one or another ?
javyb
10th May, 2015, 10:02 PM
hello javyb
i write it from boot mode tricore
Was u writing file back that you read from the ecu or file from another ecu
Group MB Best
10th May, 2015, 10:57 PM
sorry
i intend to write original file in ecu another
original ecu is damaged
thanks
H.Wessel
10th May, 2015, 11:45 PM
sorry
i intend to write original file in ecu another
original ecu is damaged
thanks
You can not do it in edc17, edc17 has OTP sector so forget about do it...
Group MB Best
11th May, 2015, 06:30 AM
Sure you want your words ? H.Wessel (http://www.digital-kaos.co.uk/forums/member.php/186921-H-Wessel)
mario38
11th May, 2015, 12:53 PM
verification stable 12volt power and connections between bdm and ECU .. maybe some connection between bdm and ECU is not good
Tachodiag
11th May, 2015, 12:58 PM
what bdm my friend ? its edc17 bootmode tricore...
if you want to swap ecu only immo off work with another one...
electronicservicemate
11th May, 2015, 09:08 PM
otp sector not possible write again no way
Tachodiag
11th May, 2015, 09:42 PM
read flash from second ecu, make it immo off, start the car, job done...
Group MB Best
11th May, 2015, 11:34 PM
Thanks for your, the information
knight7
11th January, 2018, 08:42 PM
hello
i want to help me in this problem
when i want to write flash
when it up 4% it give me an error in writing
my ecu it opel insignia EDC17CP19
my picture is
thanks in advance
Hi! Can you tell me what Galetto v54 you use ? Original or China? and what version software?
I have opel insignia 1,6Turbo 2010, ECU = Bosch ME7.6.4 and I don't know what i can use for this car Galetto, KESS , KTAG or any other? (Original or China)
Thank you.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.