CARPARTS
8th June, 2015, 01:42 PM
I have car MINI R56 ONE D / 1.6 from 2010, what was done somewhere else for km-change.
Right after this "programming", the engine goes in limp mode (max 3000 rpm)
The DASH was done by 35080, the CAS module by OBDII.
I read "unkown DTC P4049" (with autocom, as also with AVDI)
After erase DTC, the engine goes back normal, no limp mode UNTIL you shut off the engine, wait for 1 minute and start again.
Then you will have again same problem ; limp mode (max 3000 rpm) until you erase DTC.
Very very strange...
Someone encountered this problem before ? Solution or advices ?
Thx
Right after this "programming", the engine goes in limp mode (max 3000 rpm)
The DASH was done by 35080, the CAS module by OBDII.
I read "unkown DTC P4049" (with autocom, as also with AVDI)
After erase DTC, the engine goes back normal, no limp mode UNTIL you shut off the engine, wait for 1 minute and start again.
Then you will have again same problem ; limp mode (max 3000 rpm) until you erase DTC.
Very very strange...
Someone encountered this problem before ? Solution or advices ?
Thx