PDA

View Full Version : Kess software to work with clone with reset switch



ducatisti
15th June, 2015, 11:07 AM
Hi all . I have a kess unit that has 2.08 software and a reset switch .

Some of the bike protocols on 2.08 even original has checksum errors. Has anyone any ideas if there is another software I can run on this unit without bricking it ? It already has 4.036 firmware

Also is there anyone who can update a kess slave to full master without changing the PCB board.

Thanks

heteromies
15th June, 2015, 11:50 AM
Hi all . I have a kess unit that has 2.08 software and a reset switch .

Some of the bike protocols on 2.08 even original has checksum errors. Has anyone any ideas if there is another software I can run on this unit without bricking it ? It already has 4.036 firmware

Also is there anyone who can update a kess slave to full master without changing the PCB board.

Thanks

I think its useless use newer software than 2.08 with that firmware. Slave no need changing all pcb to update Master, only MCU need replace.