View Full Version : DPF off Siemens PPD 03G906018EM
JFR-Tuning
20th June, 2015, 07:08 AM
Hi friends,
please need a good solution Dump for this ECU in a Passat 2,0 TDI 170 HP 2008
03G906018EN
my solution not work. I have allways the DTC P08194 ( DPF no funktion )
i disconect the Exhause temperatursensor. I drive more than 50 km but not work.
Any help pleasehttp://www.mhhauto.com/images/lina/049.gif
tunertool
20th June, 2015, 08:11 AM
See attached. Pass in PM.
JFR-Tuning
20th June, 2015, 09:40 PM
On Monday i will Test and Report thanks
JFR-Tuning
23rd June, 2015, 06:27 AM
Hi M8,
i will Report :
not Works. The fault Lampe DPF is on. The Engine and glow Lamp are dark.
if i read with vcds i have no trubble Codes. If i read with Readline Codes OBD i found 3 trubbles.
lamdasonde and lamdasonde Heating and AGR
i Drive more than 50 km i disconect the exhausetemeratur Sensor , i make a Regeneration Codes
any help please
stop this Lampe i burn this car
tunertool
23rd June, 2015, 07:27 AM
Do NOT disconnect sensors and make DPF reset before writing file.
This is 100% tested solution :)
JFR-Tuning
23rd June, 2015, 08:45 AM
Ok Thanks for answer,
i Think there is any Sensor defekt . on of the temperatur sensors. So i cant make a DPf Reset. If you mean reset with regenartion. In "Anpassung" i have 0 Asche
tunertool
23rd June, 2015, 10:04 AM
Temperature sensors would not cause limp mode.
Also you mentioned AGR... is your EGR faulty too?
Thanks
JFR-Tuning
25th June, 2015, 06:01 AM
I will Test the EGR. But this is possible to make Off in the dump ?
JFR-Tuning
25th June, 2015, 06:50 AM
Any help please possible to Flash a Full bdm dump And make immo Adaption ?
JFR-Tuning
25th June, 2015, 08:13 AM
here are the org komplett read with galetto
any help please , EGR off ?:rofl:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.