PDA

View Full Version : DPF off Siemens PPD 03G906018EM



JFR-Tuning
20th June, 2015, 07:08 AM
Hi friends,

please need a good solution Dump for this ECU in a Passat 2,0 TDI 170 HP 2008
03G906018EN

my solution not work. I have allways the DTC P08194 ( DPF no funktion )

i disconect the Exhause temperatursensor. I drive more than 50 km but not work.

Any help pleasehttp://www.mhhauto.com/images/lina/049.gif

tunertool
20th June, 2015, 08:11 AM
See attached. Pass in PM.

JFR-Tuning
20th June, 2015, 09:40 PM
On Monday i will Test and Report thanks

JFR-Tuning
23rd June, 2015, 06:27 AM
Hi M8,
i will Report :

not Works. The fault Lampe DPF is on. The Engine and glow Lamp are dark.

if i read with vcds i have no trubble Codes. If i read with Readline Codes OBD i found 3 trubbles.

lamdasonde and lamdasonde Heating and AGR

i Drive more than 50 km i disconect the exhausetemeratur Sensor , i make a Regeneration Codes


any help please

stop this Lampe i burn this car

tunertool
23rd June, 2015, 07:27 AM
Do NOT disconnect sensors and make DPF reset before writing file.

This is 100% tested solution :)

JFR-Tuning
23rd June, 2015, 08:45 AM
Ok Thanks for answer,

i Think there is any Sensor defekt . on of the temperatur sensors. So i cant make a DPf Reset. If you mean reset with regenartion. In "Anpassung" i have 0 Asche

tunertool
23rd June, 2015, 10:04 AM
Temperature sensors would not cause limp mode.

Also you mentioned AGR... is your EGR faulty too?

Thanks

JFR-Tuning
25th June, 2015, 06:01 AM
I will Test the EGR. But this is possible to make Off in the dump ?

JFR-Tuning
25th June, 2015, 06:50 AM
Any help please possible to Flash a Full bdm dump And make immo Adaption ?

JFR-Tuning
25th June, 2015, 08:13 AM
here are the org komplett read with galetto

any help please , EGR off ?:rofl: