Volvo s40 2.4 D5 DPF+FAP off

[lechu12]

Hello please help dpf+egr off VOLVO S40 2.4 D5
ecu EDC16C31 0281012103

thanks



http://www74.zippyshare.com/v/8ATDnR80/file.html

[lechu12]

Can anyone help?

[pulsar2000]

out of interest how you read bdm or pin43 k line ? rear of ecu ?

[lechu12]

By k line I could not read. Therefore, the content is read by the BDM. The programmer is Galletto

[pulsar2000]

By k line I could not read. Therefore, the content is read by the BDM. The programmer is Galletto

u try k line pin 43 ? galletto yes ? i need to try with kess tomorrow , you know if volta works ?

someone made me a dpf off file, i tried and get immo error, car not start, i never wrote eeprom area, just flash, i put orig on and all ok,

[lechu12]

Yes ready to Galletto for pin 43 k line, not works. I triied volta and it didn't work. Car not started

[pulsar2000]

Yes ready to Galletto for pin 43 k line, not works. I triied volta and it didn't work. Car not started

thanks. did you get immo error ? anti skid etc ?

[lechu12]

Exactly. So how do you write

[pulsar2000]

Exactly. So how do you write

sounds like manual soloution and a smart guy :>
as clearly volta sucks on this as car wont start and anti skid message etc,
no one offers you a soloution ? i have to take another look tomorrow to get car out of limp mode and proper dpf off, solution

[lechu12]

Ok. I'm looking forward. Thanks

[pulsar2000]

ok pin 43 as you know you need to drill small hole maybe 0/8mm or 1mm,
i then use green k line, wire from fgtech and 12v and earth to cable,
this then allows id and read (only) no write as write protect, via rear off ecu, small connector,
point of interest, kess v2 clone, no go, adjusted speed for read, addidional power to battery, wake up error,,,,using said k line colour - Yellow, as kess help file instructs

Seems as much as you can read via k line, on rear of ecu, no write possible, so a bdm job,

[technic]

I have read/written many 0281012103 Volvo ED16C31 over K-line...

[konopel]

Here is your DPF OFF+EGR OFF file.
Pass in PM.

[kfmc]

Here is your DPF OFF+EGR OFF file.
Pass in PM.
Can you send me pass for this file?
I have some problems dpf with volvo v70.Thanks

[lolilocortachispas]

can you give me the pass too please? i have a s40 what start and stop after make dpf off, i read this with bdm100 cmd software, i put ori the ecu and the same problem, i think is a bad read file. thanks

[CustomCars]

can you give me the pass too please? i have a s40 what start and stop after make dpf off, i read this with bdm100 cmd software, i put ori the ecu and the same problem, i think is a bad read file. thanks

not possible bad reading, after write car will be dont start.
Post readed file and we check it.

[lolilocortachispas]

360831
this is the original file, start and stop when grabs injector failure (bad sign), clear errors for restart and come back to grab failure in another injector (aleatory), i try other ecu and the same, i think what can't be the pcb because are broken the same when lift up??

i want to try other software for discard some problem in ecu

really thanks

[digi-tech]

can i have pass please