View Full Version : EDC17C41 DDE8 520d F10 Ktag 6.070 can't read
fronzethenight
21st July, 2015, 02:36 PM
Hi,
anyone had problems to read EDC17C41 DDE8 520d F10 ecu with ktag clone?
my only read 76% and give me an "error Reading". i try every thing and nothing...
it read eeprom but processor only read 76%.
i try with and without 16pin rainbow cable and is the same... i take a look in rainbow cable connection in board and pins not connect nothing in the board...
i check componentes in board and is the same like original Ktag board foto...
anyone have some idea?
thanks
telucu17
21st July, 2015, 08:00 PM
I have seen in a russian forum that they replaced oscilator near the nxp processor
telucu17
21st July, 2015, 08:19 PM
I think if it had tp that ktag doesn't support it won't let you read it at all. Anyway if you have problems reading it I advice you not to write it
Alpinesport
21st July, 2015, 08:43 PM
you need boot and 2 rainbow cable yellow and orange and you have placed the yellow and orange on the wrong spot
vicius_the_one
21st July, 2015, 09:27 PM
once you use proper rework and propers software i dont have reason for for any improvisation. smd oscillator is from Murata, very good quality. I saw any kind of ktags. They do now all types of ecu nowadays. Sw has also a huge contribution
mbtun
22nd July, 2015, 07:29 AM
And let's see ... you offer both rework and sw update because here it's just like a supermarket :)
fronzethenight
22nd July, 2015, 09:54 AM
you need boot and 2 rainbow cable yellow and orange and you have placed the yellow and orange on the wrong spot
hi, i put correct rainbow cable in two correct spot...This happens with and without rainbow cable connected... ktag reads only 76%...
i will rework andi will see what happens
thanks
Youneselm
22nd July, 2015, 06:03 PM
If you rework hardware good, and have a good power suplier. It Will work. I made 26 f-serie without anny issue.
LATTINO
31st July, 2015, 02:39 AM
yes, rework is necesary with good component, buy too necesary good power supply
666_devil
13th August, 2015, 12:34 AM
Did it worked in the end after rework, share with us.
CarMirek
7th October, 2015, 09:40 PM
Hi I have the same problem with reading edc17c41 and edc17c45 BMW Fxx ecu
Errors 76 % reading ...... have you ever solution ????
xxginxx
9th December, 2015, 03:11 PM
Me cant read edc17cp46 benz... i connect all like in help file but got error check power wire 0x100b...
CustomCars
9th December, 2015, 05:54 PM
Check your connection and tool quality,
J_amb_o
9th December, 2015, 05:58 PM
I have an idea, contact Alientech and order a proper tool...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.