PDA

View Full Version : Genuine Kess Ktag slave to master



stecarolan
23rd July, 2015, 11:12 AM
Hi guys i recently updated my china clone to the latest firmware/software available at present, do you know if i can do the same procedure to change a genuine slave tool into a master ?

ominimicu
23rd July, 2015, 11:19 AM
Yes + it needs new NXP

stecarolan
23rd July, 2015, 12:02 PM
Yes + it needs new NXP
oh cant you just flash the original thats on the tools

ominimicu
23rd July, 2015, 12:19 PM
NXp is locked with CRP 3 on the slave

stecarolan
23rd July, 2015, 01:22 PM
NXp is locked with CRP 3 on the slave
right i get it so anytime you get a update on a legit slave all the files are going to the sdcard??

tunertool
23rd July, 2015, 05:50 PM
Yes it can be done to version 2.08 and works a treat...

stecarolan
23rd July, 2015, 08:33 PM
After updating my clone I played with the reset file and clicked and since then everything has greyed out. I have wiped the sd and it has installed all the protocols etc a very helpful guy has been helping me and sent me a token file for uploading new tokens but it doesn't seem to be working for me

gazvts
23rd July, 2015, 08:36 PM
:02.47-tranquillity: why play with token file when you already updated the tool ?

stecarolan
23rd July, 2015, 10:47 PM
Lol it wasn't intentional I was just looking to see how it was done and I clicked and it did it. Any ideas if it is fixable our is it time for a new ine

gazvts
23rd July, 2015, 10:51 PM
not sure if fixable as i never put myself in that situation run the software ksuite check info button if your client an customer code not good buy new nxp

stecarolan
23rd July, 2015, 10:53 PM
It's payday next week think I'm just going to start a fresh with the latest kess and ktag plus I don't think my soldering skills are good enough to fit a new chip

ominimicu
24th July, 2015, 12:07 AM
i dont think u need new NXp...it can be solved with new activation

stecarolan
24th July, 2015, 01:28 PM
and how do i do that then??

gazvts
24th July, 2015, 01:37 PM
Using the ksuite update kit again

Chippy0815
24th July, 2015, 04:16 PM
@stecarolan
pm me and tell me pass and ID from Teamviewer....i can help you....for free..

bugarcek
15th March, 2016, 11:57 PM
Hello
I have kTag slave version 2.21

FW: 7.020

What I need to do, to unlock it to master?
I never done this before

teamtuner
16th March, 2016, 07:46 AM
change nxp or contact alientech

megane2
17th March, 2016, 01:07 PM
can you send me the k tag software/firmware due to my china clone stop response and i need to update it

peko
11th July, 2019, 05:56 PM
hi friends

anybody have good adress to change ktag slave original to ktag master clone ?
i read is just replace NXP inside

thank you ;)