Nissan Note 2007 key coding

[sparkz02]

I have an original key from 3d. I have correct pin code (ordered in) still can't code this key.


Mvp goes through motions, ask is light on or blinking, I always select yes, because light is on and doesn't blink.

At the end says failed wrong key.

SBB says key not loaded.

Could it be a dodgy key from 3D? Or something else is the problem?

[lion0304]

Key not loaded usual meaning wrong chip. I did a megane scenic1 10 days ago.
History is original key stop working, i tested key show ID 4D64, Making a scan, nothing wrong. Immo still active. Change antenna coil and still the same.
i've tried recode by SBB, Renault pin extractor and Canclip. All said key not loaded or ECU disconnected
At least, change a blank 4D60 and programme, and magic key loaded and start engine. Re-test key, it showed 4D60.

[kemaster]

Key not loaded usual meaning wrong chip. I did a megane scenic1 10 days ago.
History is original key stop working, i tested key show ID 4D64, Making a scan, nothing wrong. Immo still active. Change antenna coil and still the same.
i've tried recode by SBB, Renault pin extractor and Canclip. All said key not loaded or ECU disconnected
At least, change a blank 4D60 and programme, and magic key loaded and start engine. Re-test key, it showed 4D60.


This sounds like "Swap Immo" Situation. Common problem on Megane using ID 4D64. If key counter is not "0" then go to "Swap Immo 1" function and key will start the car again. No need to program new key

[sparkz02]

I'm aware it might be a key problem but its an original key. Plus due to the fact is a renault system normal transponder wouldn't work to test.

[zippy82]

Use modus on mvp and it will work, I've had it before

[cjawahir]

i think your pincode is wrong , what type key you have pcf7946 ?

cj

[zippy82]

If the remotes a NR9 from 3D and using MVP that should read the pin code from the car automatically and then program the key, going under note on AD100 has never worked for me just use Renault modus

[sparkz02]

I'm going to order another key and try again tomorrow will keep you posted.

[cjawahir]

I'm going to order another key and try again tomorrow will keep you posted.


what type key is it ?

cj

[sparkz02]

normal key, bladed key

[sparkz02]

How do you make it read pin auto? When i click on note, it says enter pin, I enter pin, then it says to read pin 2 tokens will be used. but it just goes to programming screen, pretty pointless once ive entered pin.

[zippy82]

Is it a clone mvp? AD100pro just reads pin automatically and then programs the key

[sicodelico1869]

1-when you put the pincode and accept it, the light should be static if the key is correct it flickers a few times and off
2. if the key is incorrect must be static and then flash
3. If all the time is flashing the pin code is incorrect
You can give us the serial number of BCM and will gladly give you the right one.

[sparkz02]

New key sorted the problem, programmed first time.