Sim4lke / Sim4Le DTC off anyone?

[automocion]

Hi! Anyone can make DTC off in this file from Mercedes C180K 143hp 2005 year?
AVDI diagnostic error code its: 2038 A30/2 (Rear knock sensor (right side of engine) (P1325, P1327, P1328).
Both knock sensors have been changed and also oxygen ones but car still have MIL light on. Overall car runs fine, nothing strange.

Im ready to pay for an working solution.

Br328368

[Aajii]

Hello!
Is there oil in wiring loom / ecu connector? (caused by camshaft solenoid sealing leak?).
I had one customer with oxygen sensor fault(everything was changed and double checked),
problem was repaired by changing ecu.
It is possible to clone used ecu.

[automocion]

Yes ecu conector have oil inside.
Clone can make by bdm, obd and exchange eeprom or?

Thanks

[Aajii]

Yes ecu conector have oil inside.
Clone can make by bdm, obd and exchange eeprom or?

Thanks

Maybe problem can be in wiring / ecu connector. Try to clean everything.
What are meanings for dtc codes?
Is p2038 Oxygen sensor dtc?

I have had some kompressor mercedes with oil in harness symptom and mixture adaptation/oxygen sensor dtc.
One of them was fixed by cleaning ecu connector/harness + clearing adaptation values with mb tester + software update.
One needed new(used) ecu (other workshop made tens of hours work to find the problem. Lot of parts changed)
Usually problem is also high exhaust emissions (co% too high at idle).
I think you know that there are several things to check before changing ecu :)



Cloning:
Buy ecu with same hw number.
Open ecu.
There is flash 29F... desolder flash and solder to "new" ecu.
Immo is inside flash.

[Aajii]

OBD is reading only partial, not full.

[boomeer]

hi try dtc off
pass pm