bugarcek
2nd September, 2015, 06:45 PM
Hello
I have problem with some volvo s60.
I have done a lot of volvos via galleto k line option...
On this ecu there was too much power so I wanted to mod it with smaller power.
I read ecu without problem and program it with some other file, but now car wont start. On cluster I can see esp light and there is no cranking.
I attached ori flash read now from ecu and ori eeprom... Could the problem be in eeprom (immo?)
Have I read the full flash with this k line option?
If I use some other bdm file with bdm100 and move ori eeprom, can I than solve the problem?
I have problem with some volvo s60.
I have done a lot of volvos via galleto k line option...
On this ecu there was too much power so I wanted to mod it with smaller power.
I read ecu without problem and program it with some other file, but now car wont start. On cluster I can see esp light and there is no cranking.
I attached ori flash read now from ecu and ori eeprom... Could the problem be in eeprom (immo?)
Have I read the full flash with this k line option?
If I use some other bdm file with bdm100 and move ori eeprom, can I than solve the problem?