maxa01
6th September, 2015, 03:58 PM
Hi, to all users reading this
After success reading Mazda6 with Denso ecu when i put ignition off, voltage fall first from 12,03V to 3V only on KessV2. Red light on programmer was and is still red when i conect to USB
I had no internet conecton...
After this i tryed to disconet my KessV2 from computer and conect it and start K-Sute program whrte down connection not established.
Tryed allredy to reinstall on other computer the program and change 3 USB cables and haves still same problem...
Alssow when I conect to other computer my KessV2 via USB compiter do not recognize device.
Thanks all helping me
After success reading Mazda6 with Denso ecu when i put ignition off, voltage fall first from 12,03V to 3V only on KessV2. Red light on programmer was and is still red when i conect to USB
I had no internet conecton...
After this i tryed to disconet my KessV2 from computer and conect it and start K-Sute program whrte down connection not established.
Tryed allredy to reinstall on other computer the program and change 3 USB cables and haves still same problem...
Alssow when I conect to other computer my KessV2 via USB compiter do not recognize device.
Thanks all helping me