bmw e60 compare files

[credoline]

I have one doubt. Here are attached 2 files, both from same ecu. First file is read with unknown tool (and its sized 1536kb) from one guy. And another one is read with Galletto2 tool 0386 and it is big 2048kb. When i compare them i found that first file (1536kb) have much more content in comparing with second one (2048kb). Second file is read on desk with Galletto2 without using boot point, only power supply and CAN lines. Car is BMW 520D 2007-2008 E60. My question is:
Can i use file read with Galletto2 and write in another ecu with atention to clone ecu ?
When i try to read with boot point Galletto2 do not connect on ecu. I read with selection of Car/BMW/5 series E60. I did not try to select Tool Boot Mode.
Anyone can guide me in right direction, what to do, to clone ecu ?

[credoline]

I read it now with TOOL BOOT MODE and read it eeprom and flash separate. I still have a question:
If i write eeprom and flash to another ecu with same Bosch numbers, will car start ?

Thank you

[mihaiservice]

Hi
if OTP are not are active will be ok

[credoline]

Here is the picture of Gall2, can i see it here it is OTP active or not ?

This is picture from ecu which is broken, i am still not buy a second one.