View Full Version : k-tag clone no 12v output to ecu
busaman
17th September, 2015, 08:36 PM
my k-tag has just stopped working the k-tag no 12v output to ecu pins on either of the red wires has anyone had this problem and is there a fix.
hcsaibot
18th September, 2015, 10:37 AM
Check both 08p06p mosfet's (M2, M3)
busaman
18th September, 2015, 11:11 AM
what problems do they have and do you know the location.
regards
teerak2uk
18th September, 2015, 11:23 AM
When you say stopped working I presume it did put 12v on the red wire only reason for asking was I read some of the cables are incorrectly wired.
teamtuner
18th September, 2015, 11:33 AM
you have 12 volt only if you touch "read" buton
busaman
18th September, 2015, 12:07 PM
ok it was working fine ok i presumed there was a permanent 12v feed from there when it is powered up so you are saying only 12v when you press read.
busaman
18th September, 2015, 12:22 PM
you are correct sir i must have another problem thank you.
busaman
18th September, 2015, 08:23 PM
i also found i have been trying to read delphi mpc555 in k-tag instructions it says only 12v to pin 4 of ecu but it would not connect until i added an earth to pin1
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.