audi a4 2005 seat belt tensioner igniter.

[pouleddy]

Hi, i have audi a4 2005 with airbag unit number 8E0 959 655 G ,i just have 1 fault 00655- seat belt Tensioner igniter passenger side (N154) short to grownd. all wires i check it they are ok.i try change the (N154) still the same fault present,is there any solution for this to repair? or must buy new one or ??? thank you....

[vlaki electric]

try to put resistor to see do you have problem with tensioner or something else... if be ok you must buy new one :)

[pouleddy]

try to put resistor to see do you have problem with tensioner or something else... if be ok you must buy new one :)
i try put resistor before change the (N154) and the fault be the same no changes in the massage of the airbag.did this kind airbag unite can repair? or must buy brand a new airbag unit???

[jonce1555]

You need a new module, problem in the unit, not the airbag

[vlaki electric]

i try put resistor before change the (N154) and the fault be the same no changes in the massage of the airbag.did this kind airbag unite can repair? or must buy brand a new airbag unit???
after this post i think to is problem in unit

[pouleddy]

You need a new module, problem in the unit, not the airbag
OK. so I must buy brand new (AIRBAG control unit 8E0 959 655 G) ?

[jonce1555]

OK. so I must buy brand new (AIRBAG control unit 8E0 959 655 G) ?
You can buy ither a new one or a used one, it doesn't matter, but the codes on the unit must match, and after that you might need to code the unit correctly to your car.

[pouleddy]

You can buy ither a new one or a used one, it doesn't matter, but the codes on the unit must match, and after that you might need to code the unit correctly to your car.
Please can you give me how can done the full procedure if i wont to install used or new (control unit) for each one step by step? i have original vcds.

[jonce1555]

The VCDS shows everything, all the numbers and coding for your exsisting airbags