JammerOne
26th September, 2015, 12:44 PM
Hello there mate ..
is there anyone can help me how to calibrate Temperature and Fuel Gauge ..
unit is Isuzu DMAX 2005 ..
Thanks
toastedsiopao
27th September, 2015, 10:45 AM
Attached is an orig bin file.
Rerouter
27th September, 2015, 10:52 AM
As this is a yazaki algorithm, count me in as interested, Heck i'll even publicly post a script to set the odo / alter this calibration if someone can describe how its controlled, I may even value add.
If it is anywhere in there OP, it will be on or after line 0x70,
However form the pcb in your other post, i'm 90% sure you just have a bad soldering issue, :/
JammerOne
27th September, 2015, 10:52 AM
here is my backup ...
333035
thanks
JammerOne
27th September, 2015, 11:04 AM
OZIBO Pic inside
333037
toastedsiopao
27th September, 2015, 11:21 AM
There is no need to remove the meters, just use the solder pads and lower you UPA voltage when on in-circuit programming.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.