sync toyota hilux key immobox and ecu

[jjrp255630]

hi, i have a problem with a toyota hiace D4D with immo, i try to make a key, but car try start and cut, i think that is sync with ecu and immobox, can be fixed?

regards

ECU:

89661-26790
2KD-FTV
175800-6113

Eprom: 93c56


IMMOBOX:


89780-16100
MODEL RI-2BTY

eeprom: 93c66



dumps and key ID are in file atached

regards

[Bllinda]

I hope visible ti.r.is for.mat ....

[jjrp255630]

hi, thanks but dont work, if i put a virgin dump, immo light switch off , car try start only 2 seconds after off.

and i have DTC B2799 in ecu


regards

[iamfooser]

Try to bridge pin 4 and 13. Then ignition on for 35mins. That should do the trick.

Sent from my SM-N910C using Tapatalk

[saleh ahmed]

Hey there
First try to bridge pin 4 and 13. if no solved
1.write this vergin dump to 93c66,all old and New
Key registerd automatically
Good luck.I attach the dumb

[saleh ahmed]

Send to me your email I will send you virgin dumb file
I am new for this forum I can't attach the file

[jjrp255630]

hi, i use a virgem file, but i dont know if is ok, imo light is off, car start only 2 seconds, but still same DTC on ecu.

this is the file that i use

[jjrp255630]

up..................................

[vanos batam]

hi, i use a virgem file, but i dont know if is ok, imo light is off, car start only 2 seconds, but still same DTC on ecu.

this is the file that i use
TC- TG jump 30 mint. start the car

[jjrp255630]

TC- TG jump 30 mint. start the car

hi, i try that, ignition on, short the 2 pins after 35 minutes switch off egnition and remove shunt

regards




its possible sync ecu and immo box?

[jjrp255630]

hi, its possible get a sync dump of ecu and imobox?

ECU:

89661-26790
2KD-FTV
175800-6113

Eprom: 93c56


IMMOBOX:


89780-16100
MODEL RI-2BTY

eeprom: 93c66

regards

[aketokediag]

Hello M8,
Here is what to do try and perform syncronize between the ECU and IMMO open driver's door, turn ignition ON short terminals Tc (PIN13) CG(PIN5)in the DLC/OBDII connector leave it for 45minutes the car should start.
If not work PM me, will add up key to dump for you.
Good luck

[jjrp255630]

hi, problem solved, take dump for other immobox and clone trnasponder

regards

[bigkey]

Hi all, a stolen Landcruiser ute 2010 was replaced immo box and keys from a donor wrecking car of same model. Key turn on and immo light off, but only crank and wont start.
Any help to shed some light of what need to be done would be appreciated.
I thought immo light off means keys are recognized and car should start, but I am wrong ... please help

[teeone]

hie bridge pins 4 and 13 on obd2 plug and wait 35 with ignition ON turn key off remove bridge piece nd start car

[bigkey]

Will try next week and report

[bigkey]

Hi all, a stolen Landcruiserute 2010, (pickup not wagon) missing immo box. Installed a donnor immo box and keys from wrecking car of same model.
Key turn on and immo light off, but only crank and wont start.

Bridged TC- TG (pin4 & 13) for 35 minuntes but still only cranking not start the car
I tried that 3 times already, with some extended time as well but did not make any different
Immo box 89780-60400
eeprom 93LC66B

Any help to shed some light of what need to be done would be appreciated.
I thought immo light off means keys are recognized and car should start, but I am wrong ... please help

[bigkey]

Did that (bridged pins 4 & 13 for 35 minutes) did not work.
Maybe I need to load virgin file for immo box 89780-60400
would be appreciated if someone can help

[koncimobil]

No need virgine file, just need ecu engine dump

[bigkey]

No need virgine file, just need ecu engine dump

Thanks for your reply. Can you elaborate a bit more ... if I read the ecu engine dump then you can help to modify it?

[bigkey]

Look like Christmas time and every one are busy.

MERRY CHRISTMAS AND HAPPY NEW YEARS to all

[2560172885]

4/13=35minutesok