PDA

View Full Version : help upgrade kess V2 FW



exorcistaecu
9th October, 2015, 06:57 PM
do you think I can do something? I protocols all gray, I tried to update it, it is on the level CP3
335121

morgano
10th October, 2015, 09:31 AM
You tried and "de facto" updated it, good job ;)


Regards,

exorcistaecu
10th October, 2015, 10:59 AM
why? better explained

tehnosoftex
10th October, 2015, 11:45 AM
You should update the flash by jtag or uart before make update. Now your serial number is K12036267 instead K10033818. You must change the mcu.

exorcistaecu
10th October, 2015, 11:56 AM
I no longer get into MCU with JTAG !

steps that I followed my old firmware 3.099:
1. flash 4024.bin jlink
2. format microsd fat32
3. copy folders on microsd
4. startksuite 2.08 or 2.10

teamtuner
10th October, 2015, 01:44 PM
you reflashed with 4.024 fw your nxp
and you don"t veriffy is update folder of your 2.08 is empty...it haved the 4.036 updates inside...so,when you started k-suite,also maked the 4.036 updates...
only one things you can try now
reflash nxp again with 4.024 by UART with .hex file fw...that if is not crp3 and it rested only crp2...
and format sdcard and rewrite again 4.024 sdcard
and also....empty update folder from ksuite
regards

morgano
10th October, 2015, 02:58 PM
No way, 4.036 is crp3 locked. He updated the unit very well ;)


Regards,

exorcistaecu
10th October, 2015, 03:06 PM
I put exact fw 4024 then started kess 2.08 that upgrade folder containing folder contains upgrades crp3 protect , jtag e uart not does not connect ! I can do nothing to run to this the fw 4036?
335242335243

bobolin4o
10th October, 2015, 03:32 PM
Mate, the guys already said... first of all you must change the NXP processor, then... i don't know how this F*****g KES must be updated, actually i don't care about it.
But the most important is, that you don't have a minimal knowledge how to do this... So, contact with morgano, or treamtuner personally and follow the instructions with huge attention...

And finally, with all respect to you, will be nice if you use understandable english... If your knowledge in this materia is weak, use the F*****g google translator to correct your grammar... like me for example.
Cheers!

teamtuner
10th October, 2015, 03:42 PM
verry simple english...BUY ANOTHER KESS OR CHANGE NXP::::)::: and let who know better than you to update your tool
regards

exorcistaecu
10th October, 2015, 03:58 PM
then change nxp !
1. flash 4024.bin jlink
2. format microsd fat32
3. copy folders on microsd
4. startksuite 2.08 or 2.10 ( folder Update Empty)
5. RESET - flash 4024 for reset.hex" with u-link serial mode and Flashmagic


the steps are correct? There ksuit 2.08 different?

teamtuner
10th October, 2015, 04:28 PM
you need 2.07 better....and now,you know about too much...i will stop