View Full Version : vagcom issue coding abs audi 5.7

16th October, 2015, 06:01 PM
Hi to all, i?m experiencing a problem with a 5.7bosch abs, coding (0000) and i?ve done a few before basic coding login, in this case 09555, and coding 04255 matching coding, 12345 workshop and after i press do it it seem that drops the comms and back to 0000 coding...
i?m using v11.1 version (china clone) is it a cable problem?

Br pedro

16th October, 2015, 11:07 PM
Wrong topic :D. Car model, more infos...
You will need special login code to code ABS 5.7

16th October, 2015, 11:35 PM
Check the steering angle sensor in measure blocks does it giving you correct information in degrees when you move steering wheel.

17th October, 2015, 04:39 AM

17th October, 2015, 08:47 AM
procedure: http://wiki.ross-tech.com/wiki/index.php/Audi_A4_(8E)_Brake_Electronics_(Bosch_5.7)#Coding
pay attention to production Codes: http://wiki.ross-tech.com/wiki/index.php/Production_Codes_(PR-Codes)_can_be_found_on_the_Vehicle_Data_Label
and after succesful coding do propper steering angle G85 Basic settings if you have error codes related to this G85.
if all was succesful and you have error with sitem test active, follow this instructions: http://wiki.ross-tech.com/wiki/index.php/01486

Tested procedures many times! is not a vcds issue, you do something wrong or some condition is not meet.

17th October, 2015, 09:37 AM
hi again, thank you all for your answer, but i double checked all the logins the car its a 2003 audi a4 manual gearbox and 1lb brakes so the login its 09555 and the coding its 04255, i know this is correct, usually with older version from vag 10.4 i?ve done a few...

17th October, 2015, 11:26 AM
ABS 5.7 is not for A4, but A6 and A8. Your login and coding is not ok 100% sure. Thats why ABS doesn't accept new coding