SSANGYONG KORANDO C dcm3.7

[martis27j]

Hi maybe some one have ori file from SSANGYONG KORANDO 2011Y. 2.0XDI DCM3.7( UCA34H187_D20DTF)
Its be good from BDM reading, and OBD.
I need to compare my. because i think the dump is corrupted.
Thanks for any response

[Babos]

JTAG not bdm some tool can read via OBD

[ssarim]

In this case, always bench reading with links on back side of board

[martis27j]

Ok but some one have the good dump? or maybe have ideas to repair ?

[martis27j]

I reading with links on back site. But i thinks the ecu dump is corrupted. because car starting but not accelerate.
Thanks for any good ideas

[martis27j]

337778Any one have ideas to fix dump?

[ruklis]

have you checked the A/T ecu? This will also cause limp home mode with huge limitation in power.

[martis27j]

what you mean check A/T ecu. the car is manual 6speed gearbox.

[ruklis]

ok, if it is manual, then no question.

[Andrei2015]

original file for you337839

[martis27j]

Thanks i will try to find out.

[martis27j]

Your its read by obi? not full read?
Maybe you have read by JTAG.

[martis27j]

Any body? no one have?
HW:28283968
SW:UCA34H187

[martis27j]

NOT FROM OBD READ. I NEED JTAG READ.

[martis27j]

ANY HELP , I CANT FIND DUMP FOR THIS ECU.

[UgDen]

352269352270352271

This car is Kyron DCM3.7, but label of ECU - Korando C
And they have your ID
Reading - JTAG

[daniel guerra]

Did you checked the injector codes to see if they're properly set up? It happens once with a DCM 3.5 the car started and did not accelerate and it was one injector code, without correct code.

I hope it helps

[MAAB CHILE]

TEST THIS ECU