Agile Montana 94701048xc good dump

[Kinred]

Hi firends i have this problem: no code fault but light still on dash... only on measurement blocks reads seat belt activation but! this car do not have a belt pretensioner is equiped only with two airs, any idea?

94 801 048 XC
908az32
0d66j

[auto80]

Try n report

[Kinred]

do not work friend, crash erased but seat belt activated status is on, many thanks for your interest.

[kolocar]

check it and post results.Pass in the PM.

[Kinred]

I tested the file and didn't work, airbag light is present but no fault codes and measuring block the deployment of seat belts is on, obviously this module is defective.

[Kinred]

Hi i found a second unit from another Agile (piece of scrap) but this have a 95320 mini, please clear this crash for me, thank in advance.

[credoline]

Try it... report it.


Hi firends i have this problem: no code fault but light still on dash... only on measurement blocks reads seat belt activation but! this car do not have a belt pretensioner is equiped only with two airs, any idea?

94 801 048 XC
908az32
0d66j

[credoline]

Test it, report it.


Hi i found a second unit from another Agile (piece of scrap) but this have a 95320 mini, please clear this crash for me, thank in advance.

[Kinred]

Test it, report it.

B0053 is present (unknown code)

[credoline]

Dont forget that you use inadequate module on car. Why you not try to repair file in original module ?


B0053 is present (unknown code)

[Kinred]

Both modules are Agile and are very basic and are compatible, no can and no bi-directional wire for light.


The original module was repaired in another workshop and exchanged MCU "crashed" by another MCU "flooded", i made several attempts but for more security decided to work with a good module unflooded

One detail for all: Agile/Montana use a "special" bumper inner for Airbag function without this do no activate properly

I work with your AZ32 dump and post results

attached this pinouts for future experiences on the bench
338520338521