Please Info read and write ecu Delphi DCM3.3+

[70max]

Hello to all members of DK,
Please who can tell me how to read and write tool
this ECU.
K-TAG 6070 (clone) the can 'read and write
if you can do you give me info link.

Thank you all for your help

[Andrei2015]

From what car is it? year?

[70max]

Hello Friend,
Thank you for your answer
This ECU is a JCB excavator

[Andrei2015]

I don't think you can read/write with 6.070

[70max]

Thanks for your help.

Best regards

[70max]

Hi my friend,
I can not find in my Family 701
K-Tag
Is it very bad on my 6070 (clone)?


This exists in your family?

Thanks for your answers

[MRdiag]

This is connection for this Ecu but for that you need Ori Ktag with 7030 firmware if i not mistake/ anyway higher then 6070 and as i know china clone doesnt have higher firmware then 6070.

[tricoredc17]

Ktag 7.020 reading and end reading error checksum...

[MRdiag]

I have on the table 2 ECU DCM3.3+ and i could read both of them with firmware KTAG 7020 if anybody need flas file can contact me. One of the flash file from notprogrammed ECU so you can do ECU is new before installing. But now i have error in writing. as KTag manual says its need only 4 wiring to write this ecu but i tryed several times both of my ecu and no succes. Does anybody tried and what result? Thanks

[motorsport]

Color pcb your ktag?

[MRdiag]

i cant see because on it warranty stiker and afraid to remove it. but acually its eu clone. do you think it can be because of that?

[motorsport]

From what seller you buy?

[luiggii79]

i have same problem with read this ecu . then read but same error checsum erorr
i want scr off please enyone help thk

[thekoket]

Same problem with ktag 7.020 , cannot read

[Apsik]

Same problem with ktag 7.020 , cannot readKSuite 2.25?

[attention]

Also have same problem... When i try to read, then ksuite get error "Hardware configuration not supported: send the LOG files to the software provider"
Ktag 7.020 Eu clone

[Johndeer]

to mo its the same problem "Hardware configuration not supported: send the LOG files to the software provider"
Delphi 3.3+
Has anyone solved that problem/?

[radzio04]

Friends, help me because I have the same problem with you. Has anyone solved this problem.

[sepulchral]

bump any resolution?

[volodin69]

Did you try FGTech Galletto?

[cbvasoft]

bump any resolution?


DBFox and Galetto read / write by OBD