PDA

View Full Version : Polo 2012 JC none starter.



honingkoning
28th October, 2015, 09:34 PM
Guys i struggle with a polo, after battery run flat Car gives immo active in dash.
Car went to dealer and dealer says Car needs new dash new ecu keys etc.

Dtc available (key not defined), i programmed new key work smok.

But Car still not start, is it possible to remove all existing keys?

Any Advice would be great.

Thank you.

autofan1965
28th October, 2015, 11:47 PM
What engine is inside? What faults you have in immo and engine? Have you immo 027 activation from smok?

honingkoning
29th October, 2015, 01:21 AM
What engine is inside? What faults you have in immo and engine? Have you immo 027 activation from smok?

Engine is a 1.4 with a marelli 4hv ecu, i forget about the faulty in immo en ecu i Will check them tommorow.
I dont have immo from smok active but no problem buying this if it solves my problem.

Can you check in sec block how much keys are learned or cant this cause any problem.

Wbr Adam.

autofan1965
29th October, 2015, 11:14 AM
Post your SecBlock here.

potatodog
29th October, 2015, 12:30 PM
... and post ECU dump

honingkoning
29th October, 2015, 12:33 PM
Sec block i Will upload, what memory inside this ecu? Eep Or flash do you need.

potatodog
29th October, 2015, 12:36 PM
ECU have 95320 eeprom

honingkoning
29th October, 2015, 10:24 PM
Guys this is sec block

338674

Dtc active in ecu is P1570

In dash B104A00/B104c29/B104D00.

for ecu eep i need to go to customer as this is 40 km further.

Wbr Adam.

simaservis1108
29th October, 2015, 11:32 PM
If I am right,this dash won't give output to key reader coil.
Please check with coil checker.
I had problem with one Fabia,similar to your problem.
I resolved it quickly.