H2Deetoo
30th October, 2015, 01:56 PM
Hi guys,
I have here a Galletto v54 (clone) and I am planning to make a full backup in bootmode of my EDC17CP14 (later when I have removed it from my car).
But for now I did some tests using OBD connector in car, and it reads a nice 2 MB file (although about 75% is filled with FF's but this is normal when not in boot mode).
Does the Galletto software also read the eeprom? And if so in at what stage?
And if not, what's the easiest way to read the eeprom over CAN?
(I know I can desolder it if needed...)
Regards,
H2Deetoo
I have here a Galletto v54 (clone) and I am planning to make a full backup in bootmode of my EDC17CP14 (later when I have removed it from my car).
But for now I did some tests using OBD connector in car, and it reads a nice 2 MB file (although about 75% is filled with FF's but this is normal when not in boot mode).
Does the Galletto software also read the eeprom? And if so in at what stage?
And if not, what's the easiest way to read the eeprom over CAN?
(I know I can desolder it if needed...)
Regards,
H2Deetoo