PDA

View Full Version : Ford CMAX DPF OFF problem



xdamdamx
4th November, 2015, 12:44 PM
Hello!

I'm trying to make it DPF-OFF, but without success.

It has no DTC's, but Limp Mode is active. It revs only to 3000RPM.
Without moving you can go to the redline, but when you go, there's normal power until it reaches 3000RPM.

I've reset DPF Counter with IDS before flashing.

Tried single switch, ~~~~ty Volta file, still no joy. Also tried with disconnected Additive module.

CMAX 1.6 2007y
It's a EDC16C34,
HW 0281012487
SW 390500

Someone can share any advice? THANKS!

mihaiservice
4th November, 2015, 01:45 PM
Hi
update ecu with new software from IDS and after read again ecu !

xdamdamx
4th November, 2015, 02:00 PM
According to IDS, it's the newest calibration for this ECU. forced the reflash , but file is the same.

pinotec
4th November, 2015, 05:09 PM
post full backup.. eep+flash

xdamdamx
4th November, 2015, 05:47 PM
Here it is.

mihaiservice
4th November, 2015, 08:05 PM
Can you explain how you have reflash again your ecu with IDS and your file still not original ?

lucim12
4th November, 2015, 08:37 PM
any dpf sensors dtc ? check pressure sensor..
try removing also sensors from file

xdamdamx
4th November, 2015, 09:38 PM
mihaiservice - IDS says there's no newer calibration file than the one in ECU. Then i choose "installation of programable module" , it flashed, and when i reader it by OBD the file was 1:1 as the one i attached here (read.bin).

I tested 3 sets of FULL BDM files, also from 0281012486 - without DPF . still the same.

sensors work OK, difference press. is 0kPa (def removed) , EGT is OK.
I checked glow plugs - 3 are dead, but no DTC! I connected 3 other to the relay to simulate, but nothing changed.
that's awesome.

mihaiservice
4th November, 2015, 09:42 PM
Your file not are original !!! 90% of dtc table are deleted by a smart guy !
That "check engine-fault" from dashboard are come from ecu via CAN BUS !
How you have tested 3 set of file ? all 3 sets are with dtc area deleted ?

xdamdamx
5th November, 2015, 09:53 AM
Today i didn't turn ignition on, IDS told me to enter ECU NR, VIN etc... and flashed it correclty from zero. And then .... P2141 Throttle Valve DTC found!
Mihaiservice! - thank you so much for assistance! I'll read it again by OBD and attach here for comparisons.
On other BDM files i had MAF/IAT sensor DTC, that's what made me think wrong way.

OK, it was a FUSE blown, now NO DTC's, and ..... after a short ride i have P1412 - EGR blocked. I'll try to disable it.

here is a read from BDM after IDS flash.

ciptel07
15th December, 2015, 10:39 PM
engine from ford 16 tdci must heve all glow pug ok ,because they dont up to 3000 rpm

silvergl
16th December, 2015, 09:33 AM
HI,
you have error dtc p1187????