DASH PEUGEOT 206

[nas33]

HELLO IN ALL HERE IS I LOOK FOR TO READ DASH 206 YEAR 2000 WITH MCU MC68HC05H12 WITH UPA USB .J HAVE ADAPTER UPA BUT J HAVE NOT ENVY OF DESOUDER BECAUSE THEY ARE HARD TO RESOLDER. IF ABOUT ONE HAS HIM(IT) CONNECTION THANK YOU

[newgeniehex]

HELLO
look this picture
you can dot whitout disable the dash whit tacho 2008 or interfecae whit max 232 and licznick 4.7
best regard

[nas33]

OK thank you I n have that upa usb.for pin 6 how to lift her(it) or otherwise I cut the track pin6. What is that I have to feed my dash 12v to be able to read this mcu thank you

[newgeniehex]

try to lift the pin6 or cut the trac
no need to put the 12v only for see the mileage in the displayk

[nas33]

try to lift the pin6 or cut the trac
no need to put the 12v only for see the mileage in the displayk
OK i try and I inform you thank you

[nas33]

I come d to try but j have error here is photo339955339956

[baze007]

I come d to try but j have error here is photo339955339956



Try tested solution from me .......................upa conections

[nas33]

Try tested solution from me .......................upa conections
WHAT IT'S LIKE S DASH CAR IS NOT THE SAME MODEL 206 DASH OF .THE SCHEME HAD YOU POSTER IS FOR PEUGEOT EXPERT NO?

[baze007]

WHAT IT'S LIKE S DASH CAR IS NOT THE SAME MODEL 206 DASH OF .THE SCHEME HAD YOU POSTER IS FOR PEUGEOT EXPERT NO?



I know that dash is not the same ,but you will see conections where are make mistakes..........

[nas33]

I know that dash is not the same ,but you will see conections where are make mistakes..........ok I've done as shown in diagram upa .i lift pin 6 but did not lift the pin 7 and the oscillator frequency must be put 4194khz .so I also raised pin 7

[fuktak]

M8 that is tested solution no need disassemble dash with cheep interface rx.tx.Best Regards