corsa c immo problems

[geeroam]

Hi Guys im busy with opel corsa c 2006 1.7 dti, the vehicle was at Dealer wanted to replace ECU ended up with me I checked incorrect transponder key fault, i have programed transponder immo via obd t300 and opcom still getting incorrect TP deleted keys re added says transponder already coded, i reset immo recoded still same. replaced immo with scrapyard unit still same

[autoden]

Had one last week similar. Opcom cannot do immo in clocks. Had to take to a friend with tech2. 5mins later, done.

[autochei]

Had one last week similar. Opcom cannot do immo in clocks. Had to take to a friend with tech2. 5mins later, done.

op com it s very good for old car

i think u have waitting time and u can t add transponder

check measuring value if u have waitting time

[geeroam]

Hi Guys i have done many of these with opcom t300 tango effi and zedbull, the key is definately programmed i wasted about 5 chips with this vehicle what i even done is reset the immobiliser coded 2 immobilisers, still same fault shows the key location but under transponder status it shows invalid with opcom no faults in bcm or cluster in ecu have invalid transponder

[Shmortz]

did you try to reset ECU, BCM, IPC and program pin again, make shure VIN is identical in all units...

[CarDiag84]

ECU reset and programing
IPC reset and programing
BCM reset and programing

[geeroam]

Thanks guys i shall do that was keeping it as last resort,