PDA

View Full Version : Mercedes A-Classe inlet port shut off the engine please help



seba_m_
7th November, 2015, 06:38 PM
Please remove error 2513 - Inlet port shut off the engine so that disconect plug from Mercedes A-Class - ECU edc16c32 180cdi. The attached flash is off the DPF by ATR.

gitko
7th November, 2015, 06:51 PM
here it is removed 2513

seba_m_
7th November, 2015, 07:08 PM
I can disconnect the plug so that it was not safe mode?

gitko
7th November, 2015, 07:25 PM
mate I removed desired from you dtc

seba_m_
7th November, 2015, 07:33 PM
did not work. whether connected or disconnected continues to be the same mistake in 2513


Make: Mercedes
Model: 169.008 - A 200 CDI Sedan
Year:
VIN:
Test Time: 2015-11-07 20:26:33
Diagnostic path: System Selection > 169-A Class(Up to 11/2005) > Sedan > Diesel engine > Left-hand
steering > 169.008 - A 200 CDI Sedan > Control units > Drive > ECM - Engine Control Module(CDI)
Diagnostic Result
2513-1 Check component M55(Inlet port shutoff motor).Positioner
signals fault X.

mihaiservice
7th November, 2015, 07:46 PM
Hi
for such car it need to disable M55 actuator also to disable dtc label from flash file !

seba_m_
7th November, 2015, 07:52 PM
This will help anyone because I already have enough of that car.

gitko
7th November, 2015, 09:30 PM
Is not removed because you need to read this ecu on a bench.
And only with dtc off you can not have decision with your M55.

seba_m_
8th November, 2015, 01:00 AM
flash BDM. After disconnecting the plug is now error 2530-4 and shines a light on the board.

blazej1200
8th November, 2015, 08:51 PM
2513 dtc off
Regards

Johnner
8th November, 2015, 08:52 PM
Blaze,please post that again in English


Thank you...

CustomCars
8th November, 2015, 08:56 PM
"Dtc 2530 off

regards"

haha

seba_m_
9th November, 2015, 11:57 AM
Problem solved. Do not just turn off only the errors DTC :)