08 BMW 550 IMMO OFF

[astrofil]

Im searching for the solution to remove the EWS from 08 BMW 550i
DME 7 582 306 Bosch 0 261 209 320
Here is attached full read performed by BDM Galletto
Can somebody advise how to work this one out ?

[Mr BLACK]

bmw 08 ...no imoo off and if u find ews on a 2008 bmw post a picture pls ...i never see one

[astrofil]

How about Virgin Dump for this DME? Im trying to find online Virgin Dump Database. I don't mind paying for correct dump

[philipcoin]

mate


what is the problem on your car?

[astrofil]

The original DME was water damaged. It still comunicates over K Line and starts the car but has various other issues.
I tried to read it over BDM port and transfer all the content to donor DME . the BDM connection does not work on the original control unit.
At this point I need to read everything over K Bus ,fix the BDM port or find virgin dump.
Any help greatly appreciated.
Anybody is got any BDM port diagrams on this type of Bosch Unit?

[philipcoin]

post here
old and new ecu pictures
thank you

best regards.

[astrofil]

Picture of the original DME attached.
The donor DME is exactly the same . The Bosh part and BMW part numbers are identical

[bram380]

here you go:

[astrofil]

I could not write the file as "Write All" function . There is some fault about file dimension. So when I try to write the External Flash only S29CD016GB Galletto popes a massage saying that computed Checksum and if it should apply that before writing. Current Checksum in the file is D9C4
I assumed the Checksum is already Ok and I don't have to correct anything. Proceeded as Write External Flash without any corrections
Programming went well.
There is also Internal Flash Micro which I did not touch
Bram Do all My steps look right or should I do some corrections ?

[bram380]

read as partial (mpc, external flash, external eeprom, etc...)

[astrofil]

That is what I did. The DME boots fine. Did You correct My Bin to erase the ISN ? The DME does not appear to be virgin new. It's already coded . I will put it to the car next week and report back

[koncimobil]

You can reset ecu to delete all coding. Use NCSExpert.

[Masterprog]

hello it's tricore or mpc ? can you see your eprom if yes swap it and start if not do you have a cable K+Dkan for bmw ?