Blaupunkt MFD Z1Z7 navigation

[karim72]

Trouble reading eeprom Blaupunkt MFD Z1Z7 navigation
7l6 035 1910n
vwz1zexxxxxxx
Trouble reading eeprom
When you try to read Damp
Instead of reading the press of a button.
Pressure on the writing of a button. Then
Did not operate radio
I think the discharge is blank eeprom dumps

[shooting]

Trouble reading eeprom Blaupunkt MFD Z1Z7 navigation
7l6 035 1910n
vwz1zexxxxxxx
Trouble reading eeprom
When you try to read Damp
Instead of reading the press of a button.
Pressure on the writing of a button. Then
Did not operate radio
I think the discharge is blank eeprom dumps

Code in FIS not eeprom

wbr

[karim72]

Yes I read my fis ponyprog
But when the press on a button reading
Pressure on the writing button
I will come in after turning on the radio no display on the screen

[jackie86]

Hmmmm, somewhere i read it and you can try..:
Connect navi on bench, connect all positive terminal(in your case is 2 or 3, dont know...)
- on power supply, decrease voltage on 8,5-9v
- push power button
- navi wont start, but its posible ti read and program
Try, you have nothing to lose..
Also, measure sda and scl lines, shoud be 5v on them.
Regards,
Jackie


Sent from my iPhone using Tapatalk

[karim72]

I will try tomorrow

[karim72]

Is it possible to put a new dump

[jackie86]

Yes, just find dump from same model..
I will look tomorow in my dump base..


Sent from my iPhone using Tapatalk

[Johnner]

Mate...would you please stop spamming the place with these requests ?

Just wait for someone to reply to your post


Thank you ;)